[Mristudio-users] slice rejection
susumu mori
susumu at mri.jhu.edu
Wed May 26 19:25:51 EDT 2010
After the calculation is done, go to the "DtiMapping" tab in the lower right
corner and click the "Original-ADC-Mean-STD" button at the top right.
The rejected images should be crossed out by a large red "X" mark.
Susumu
On Thu, May 20, 2010 at 12:05 PM, Mojdeh <zamyadim at sri.utoronto.ca> wrote:
> Hi again :)
> Is there a way to find out which slices have been rejected when using
> the "Automatic outlier IMAGE_SLICE rejection" mode for DTI fitting?
> thanks,
> Mojdeh
> _______________________________________________
> Mristudio-users mailing list
> Mristudio-users at mristudio.org
> http://lists.mristudio.org/mailman/listinfo/
> Unsubscribe, send a blank email to:
> Mristudio-users-unsubscribe at mristudio.org
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.mristudio.org/pipermail/mristudio-users/attachments/20100526/4fce93ce/attachment.html
More information about the Mristudio-users
mailing list